Controlling LAN Access to the Socket WebUI

Prev Next

Overview

The Socket Web UI page in the Cato Management Application (CMA) lets you control LAN access to the Socket WebUI. You can block access or allow access only from selected source IP addresses, IP ranges, or subnets, limiting which devices can reach the local login page.

By default, LAN access to the Socket WebUI is allowed. LAN access includes computers connected directly to a Socket LAN port and devices connected through a switch. Allowed sources must still authenticate with the Socket WebUI credentials.

LAN access restrictions do not prevent access through the CMA. Access through the CMA remains governed by administrator permissions and requires connectivity to the Socket. For more about the available login methods, see Accessing the Socket WebUI.

Use Cases

Allow LAN access to the Socket WebUI only from a designated administrator workstation, such as 192.168.1.50, and block access from other LAN hosts.

Prerequisites and Considerations

  • Socket v28 or higher

Sites running earlier Socket versions do not appear in the site selector. In an account with a mix of Socket versions, you can configure this feature only for sites running a supported version.

Understanding Account Defaults and Site Overrides

The LAN Access section contains an account default and a table of site overrides. You can configure the default behavior for the account, and create site overrides to configure access for individual sites.

Each site override supports the following access modes:

Site setting

LAN access behavior

Block all

Blocks access to the Socket WebUI from all LAN sources at the site.

Allow all

Allows all LAN sources at the site to reach the Socket WebUI login page.

Allow selected sources

Allows only the configured source IP addresses, IP ranges, and subnets to reach the Socket WebUI login page. Other LAN sources are blocked.

Configuring the Account Default

Configure the account default from the Socket Web UI page.

LAN Access section with the account default checkbox and site override table.

To configure the account default:

  1. From the navigation menu, select Network > Socket Web UI.

  2. Expand LAN Access.

  3. Select or deselect Block Socket WebUI LAN access by default.

  4. Return to the Socket Web UI page and verify that the intended account setting is retained.

Configuring a Site Override

Create a site override to select the LAN access mode for an individual site. For Allow selected sources, add the source IP addresses, IP ranges, or subnets that require access.

Allow selected sources with IP address 192.168.1.50 in the allowed sources list.

To configure a site override:

  1. From the navigation menu, select Network > Socket Web UI, and expand LAN Access.

  2. Click New. The New Site Override panel opens.

  3. In Site, select the site.

  4. Select Block all, Allow all, or Allow selected sources.

  5. For Allow selected sources, configure the allowlist:

    1. Under Allowed sources, select IP Address, Network Subnet, or IP Address Range.

    2. Enter the source and click Add.

    3. Repeat for each source that requires access.

    4. To remove an entry before applying the override, click its trash icon.

  6. Click Apply. The site settings appear in the table.